WTF-J

ID

Description

1.   

Instrument Panel – Ver 2.0

• Fix turn signal LEDs hidden by radio faceplate when it tilts during operation

• Fix monolithic faceplate that requires the whole dash to gain access to any of the connectors

• Fix defective Cruise Control switch logic

• Swap Speedo / Tach positions (Done)

• Validate SES indicator operation

• Add filter module for RFID key system (Done)
• Gang “ad hoc” relays on left side (Done)
• Clean-up power distribution and segment connections
• Powder Coat Dash Panel
• Not really the IP, but add cup holders to console (Done)

2.   

Convert former A/C Compressor to OBA

• Turns out that when the suspension is really workin’ it has a prodigious appetite for air.  The Viair is rated for a 100% duty cycle and can keep up without any problems, but it’s noisy.  Yeah, yeah, I know the whole damn thing is noisy, but the electric compressor is bad noise.

3.   

Muffler – Ver 2.0 :

• Speaking of noise, find a quieter muffler to fit in the same envelope as the current Magnaflow  (Done)

4.   

Engineer New (longer) Pitman Arm

• Decrease Steering Radius

• Increase Steering Effort

• It will be a challenge to work out the interference issues

5.   

Paint

• Center “Console” (Ammo Cans) 

• Body

• Misc. Chassis Components

6.   

Spray-On Bed Liner for Tub Interior ($???) (Done)

7.   

ScanGauge II  (Done)
Reads the ECM to provide any four functions from list including:

• Maximum Speed

• Average Speed

• Maximum Coolant Temperature

• Maximum RPM

• Driving Time

• Driving Distance

• Fuel Used

• Trip Fuel Economy

• Distance to Empty

• Time to Empty

• Fuel to Empty

• Fuel Economy

• Fuel Rate

• Battery Voltage

• Coolant Temperature

• Intake Air Temperature

• Transmission Temp

• Engine Speed (RPM)

• Vehicle speed (MPH)

• Manifold Pressure

• Engine Load

• Throttle Position

• Ignition Timing

• Open/Closed Loop

Can also serve as a scan tool to:

• Read/Clear Trouble Codes

• Reads conditions that set the Trouble Code

• Turn off the "Check Engine" light

• Tell you when vehicle is "Ready" to pass OBDII testing

• Make and store up to 10 rewritable special codes to send to the vehicle computer

8.   

Rocker Guards with Step (Done)

9.   

Finalize rear speaker installation (Done)

10.

Clean-up connections at Fuel Tank (Done)

11.

Install IKEA interior LEDs (Done)

12.

Figure out why the driving lights don’t work

• They did before I installed the brake lines. Doh!

13.

Re-plumb vacuum line for heater/thermostat

14.

Front Inner Fenders (Half Done – ECM/Driver’s side complete)

15.

Front half of roll cage

• Cannot start until after Ver 2.0 Dash